Нужно включить мозг, и понять что powerBox можно использовать с чем угодно и как угодно , зная распиновки устройств, производитель не просто так дает распиновку
Connection
On the back of the CombiBox there are 2 plugs:
1. J2534 is a plug for connecting a J2534 device (Scanmatik 2 PRO).
The plug has the following connection diagram:
1 — GPT1
2 — GPT2
4 — GND
5 — GND
6 — CAN-H
7 — K-LINE
14 — CAN-L
15 — L–LINE
16 — +12V
2. DC IN 5A Max Jack is a plug for connecting power supply.
On the front panel of the device there is a DB-15 plug designed to connect to the ECU using a universal cable. All cable wires have appropriate markings to connect them correctly.
The plug has the following connection diagram:
2 — Purple, VPP;
3 — Green brown, GPT2;
4 — Blue, CNF1;
5 — Red, VECU +12V;
7 — White, CAN-H;
9 — Orange, VKEY +12V;
10 — Grey, BOOT;
11 — Black, GND;
12 — Yellow Orange, GPT1;
14 — Yellow, K-Line;
15 — Green, CAN-L.
Controls elements
«POWER» switch, power control. The device has three modes of power supply to the ECU:
«OFF», allows to remove all power and control signals from the DB-15 connector.
«ON», power is supplied to VECU and VKEY terminals, as well as control outputs depending on the chosen operation mode of the BOOT switch.
«AUTO», in this mode, power management is performed by the PCMflash.
Boot SW switch, BOOT signal control:
«OFF», allows to remove all control signals from the DB-15 connector;
«ON», pulls BOOT up to the signal minus;
«AUTO», in this mode, simultaneous control of signals is performed by the PCMflash.
«CNF1» switch, CNF1 signal control (3.3V):
«OFF», allows to remove all control signals from the DB-15 connector;
«ON», pulls CNF1 up to +3.3 V;
«AUTO», in this mode, simultaneous control of signals is performed by the PCMflash.
The device has built-in current-limiting resistors on signal lines:
«BOOT» — 1000 Ohm;
«CNF1» — 510 Ohm;
«CAN» — 120 Ohm.
Indicators:
The «Power IN» LED indicates the presence of the supply voltage;
The «Power OUT» LED indicates the presence of the voltage on the ECU;
The «Boot ON» LED indicates pull-ups on BOOT;
The «CNF1 ON» LED indicates pull-ups on CNF1.
bahtiyor отреагировал на сообщение в теме:
С3 и 38 пиновый кабель
roma130a отреагировал на сообщение в теме:
Ошибки после удаления катализатора и прошивки на Евро2 (Ford Focus 2013 hatchback)
Kacz отреагировал на сообщение в теме:
Нужна распиновка EIS для ORANGE 5 проц 4J74Y