32920-02H**/01H** Suzuki GSXR 600/750 06/07 EU/US Manual SH7054 32920-01H 0x0005C34E 384kb Enable/Disable Immobilizer.

Inlet Air Pressure Sensor Error Threshold. Turbo bikes with positive boost in the inlet will cause the IAP to go over this threshold and throw an FI error on the instrument cluster. Set to 4.98 volts to prevent this.

When checked Fuel Cut is Type 1 (Soft/Hard). Uncheck box for Type 2 (Hard Only).

SoftLoSoftHiHardLoHardHi

Values must conform to (SoftLo less than SoftHi) less than (HardLo less than HardHi) Limit enabled if rpm exceed hi value, disabled below low value, no change between values. (FuelLimFlags_1 bit1=Hard, bit0=soft)

HardLoHardHi

Type 2 disabled in stock maps. (See Fuel Limit Soft Cut) Lo values MUST be lower than Hi. Limit enabled if rpm exceeds hi value, disabled below low value, no change between values. (FuelLimFlag1 bit1)

Neu_LoNeu_Hi

Lo values MUST be lower than Hi. Type 3 is used when in Neutral/Clutch in?. Limit enabled if rpm exceed hi value, disabled below low value, no change between values. (LimitFlags_1 bit1=Norm,Neutral)

When checked Fuel Cut-by-Gear is Enabled. Uncheck box to Disable.

When checked Fuel Cut-by-Gear is Type 1 (soft/hard). Uncheck box for Type 2 (Hard Only).

SoftLoSoftHiHardLoHardHi

3rd4th5th6th

These limits used when Fuel Limit-by-Gear Enabled AND Limit-by-Gear Soft Cut enabled. Limits must be softlo less than softhi less than hardlo less than hardhi. Limit enabled if rpm exceeds hi value, disabled below low value, no change between values. These limits may conflict with other Fuel limiters that exceed stock limits. 6th gear is soft limit is 186mph top speed limit.

HardLoHardHi

3rd4th5th6th

These limits used when Fuel Limit-by-Gear Enabled AND Limit-by-Gear Soft Cut DISABLED. Limits hardlo must be less than hardhi. Limit enabled if rpm exceeds hi value, disabled below low value, no change between values. These limits may conflict with other Fuel limiters that exceed stock limits.

NormLoNormHiNeu_LoNeu_Hi

Lo values MUST be lower than Hi. Norm is Normal limit, Neu is limit when in Neutral. Limit enabled if rpm exceed hi value, disabled below low value, no change between values. When checked Ign Limit-by-Gear is Enabled. Uncheck box to Disable.

Ign_LoIgn_Hi

3rd4th5th6th

Limit enabled if rpm exceeds hi value, disabled below low value, no change between values. These limits are untested, use with caution

Fan OffFan On

When Engine Coolant Temp is greater than Fan On then fan turns on. When temp is between Fan On and Fan Off there is no change (Fan stays on if on, stays off if off) When temp falls below Fan Off fan turns off.

1st2nd3rd4th5th6th

Selects which Ignition Map Group (1-3) is used by each gear.

function unknown

Percentage of total injected volume

Calculated Manifold Absolute Pressure is (SAP - IAP) * Factor (this map result)

function unknown

Unit unknown but this map is how long coil is energized (turned on)

function unknown